RENOCLEAN GSO 3001

Description

RENOCLEAN GSO 3001 is developed for the cleaning of transport containers of all kinds, but especially of plastics, for removing oil, dust, grease and dirt. RENOCLEAN GSO 3001 is designed for use in spray cleaning equipment and therefore has no tendency to foam at an application temperature above 40 °C. RENOCLEAN GSO 3001 can also be used in immersion systems with ultrasound and manual precleaning. RENOCLEAN GSO 3001 dries quickly and leaves, when properly applied and dried, no visible residue. The use of demineralized water to avoid visible residues of constituents of the used water (calcium, magnesium, etc.) is recommended. RENOCLEAN GSO 3001 demulsifies entered oils in a connected oil separation system such as coalescence separator, skimmer etc.

Application

Application type: spray, immersion, manual
Typical Range Make-up: 2 % (1 – 10 %)
Temperature: *) 50°C (20 – 80°C)
Exposition time: 1 min (0,5 – 10 min)
Spray pressure: 2 bar (1.5 – 5.0 bar) *)
For plastics, the maximum temperature of the plastic must be observed..

Benefits

• Designed for mechanical and manual cleaning of transport containers, in particular made of plastics
• Removes oil, dust, grease and dirt
• No foaming above 40 °C
• Odorless
• Demulsifying effect, oil separation system recommended
• Dries quickly and virtually stain free, even on black plastic
• Leaves no smeary residues
• Degradable according to detergent regulation
• In combination with RENOCLEAN GTM 3001 yet faster drying of all surfaces

Storage conditions

The product can be stored in its original sealed packaging for up to 12 months at temperatures between + 5 °C and + 40 °C. The indication of a minimum period of storage does not include any guarantee of durability.

Information according to annex VII to Regulation (EG) No 648 / 2004 on detergents / identification of the ingredients

• Non-ionic surfactants 5 - 15 % - Soap < 5 %
• Other significant ingredients

Important notes:

• Observe Safety data sheet, in particular individual protection measures!
• Skin protection: Use Protective creams for the skin surfaces which may come into contact with the product, for example the RENOCLEAN range of Handcare products!

This product is intended for commercial use only!

Concentration determination

The concentration of the cleaner may be determined by following methods:

• Conductivity
• Titration
• bubble pressure method

A test method for the exact determination of the concentration about the alkalinity (FLV-K-21) is available on request. Otherwise, the analysis conditions of the respective equipment manufacturer must be observed (eg bubble pressure).

Note: All determination methods are valid in strict form only for fresh solution. In used solution restrictions must be made in accuracy depending on the impurity and dirt contamination.

Sampling

At a homogeneously mixed position take a sample of the solution and allow cooling down to room temperature. For existing sample turbidity, let turbidity settle down and decant or filter the solution sample.

Titration procedure (easy)

The determination of the alkalinity can usually determine the proportion of cleaner in the cleaning solution as follows:
Exactly 200 ml of cleaning solution to be tested are titrated against methyl orange as an indicator with hydrochloric acid (0.1 M or 0.5 M).
Color changes from orange to red.
The concentration is calculated using the following formula:
Consumption (V) in ml * Factor (F) = (K) Vol% RENOCLEAN GSO 3001
For 0.1 M hydrochloric acid F = 1.0
For 0.5 M hydrochloric acid F = 5.0
V = required amount of acid in ml
K = concentration in %